空調移機收氟方法介紹
Introduction of fluorine collection method for air conditioner relocation
安裝時，打開閥門排空如下:內外機固定后，連接空調，主要是內外機連接管緊密，注意連接，防止制冷劑泄漏。用內六角開關打開自動檔空調，打開高壓閥(細
山刷房 保定網站建設 保定強夯 卷揚式啟閉機 保定網站制作 收費島模具 遮陽網 麻繩管閥)，用六角頂住加氟口頂針(低壓加氟口)，讓里面的氣體跑出來，10秒左右，不要太久，以免雪種跑得太多，這樣管道里的空氣就可以排出。然后打開高低壓閥門，連接內外機的電源線。
During installation, open the valve to vent as follows: after the
internal and external units are fixed, connect the air conditioner,
mainly because the connecting pipes of the internal and external units
are tight, and pay attention to the connection to prevent refrigerant
leakage. Turn on the automatic air conditioner with the hexagonal
switch, turn on the high-pressure valve (thin tube valve), and use the
hexagonal to hold the thimble of the fluorine adding port (low-pressure
fluorine adding port), so that the gas inside can run out for about 10
seconds, not too long, so as to avoid too much snow, so that the air in
the pipe can be discharged. Then open the high and low pressure valves
and connect the power lines of internal and external machines
