拆機的步驟
拆機的步驟
Disassembly steps
1．回收制冷劑
1. Recover refrigerant
無論是冬季，還是夏季移機，都必須把空調器中的制冷劑收集到室外機中去。拆機前應啟動空凋器，可用遙控器設定制冷狀態，待壓縮機運轉制冷狀態正常后，用扳手擰下外機的液體管與氣體管接口上的保帽，關閉高壓管（細）的截止閥門，l分鐘（大一點的空調就等2分
鐘左右）后管外表結露，立即關閉低壓管（粗）截止閥門，同的迅速關機，拔下電源插頭，用扳手擰緊保險帽，至此回收制冷劑工作完成。（如果是冬季，宜先用溫熱的毛巾蓋住室內機的溫度傳感器探頭，然后控制冷狀態設定開機。）
Whether it is winter or summer, the refrigerant in the air conditioner
must be collected into the outdoor unit. Before dismantling the machine,
start the air conditioner and set the refrigeration state with the
remote controller. After the compressor operates normally, unscrew the
protective cap on the interface between the liquid pipe and the gas pipe
with a wrench, close the stop valve of the high-pressure pipe (fine),
condensation on the surface of the pipe after 1 minute (the larger air
conditioner will wait about 2 minutes), and immediately close the stop
valve of the low-pressure pipe (coarse), Shut down quickly, unplug the
power plug and tighten the safety cap with a wrench. So far, the
refrigerant recovery work is completed. (if it is winter, cover the
temperature sensor probe of the indoor unit with a warm towel first, and
then control the cold state setting to start up.)
2．拆室內機
2. Remove the indoor unit
制冷劑回收后，可拆卸室內機。用扳手把室內機連接鎖母擰開，用準備好的密封鈉子旋好護住室內機連接接頭的絲紋，防止在搬運中碰壞接頭絲紋；再用十字起拆下控制線。同時應做標記，避免在安裝時接錯。如果信號線或電源線接錯，會造成外機不運轉，或機器不受控制。
After the refrigerant is recovered, the indoor unit can be disassembled.
Unscrew the connecting lock nut of the indoor unit with a wrench, and
screw it with the prepared sealing sodium to protect the silk pattern of
the connecting joint of the indoor unit, so as to prevent the silk
pattern of the joint from being damaged during handling; Then remove the
control wire with a cross lift. At the same time, marks shall be made
to avoid wrong connection during installation. If the signal line or
power line is connected incorrectly, the external machine will not
operate or the machine will not be controlled.
