移機步驟
移機步驟
Relocation steps
1.確定空調移動的位置，管度的長度是否足夠?？照{的安放位置是否適合，是否符合各種要求等?？照{的重新移機也是需要符合一般安裝空調位置的要求的。應該勘察好環境位置是否適合轉移空調，再準備好需要的材料和器材。包括制冷修理工具一套，以及室內外機的固定用膨脹螺絲等材料。還有需要更新、延長等的管道等等。
1. Determine the moving position of the air conditioner and whether the
length of the pipe is sufficient. Whether the placement position of the
air conditioner is suitable and meets various requirements, etc. The
relocation of the air conditioner also needs to meet the requirements of
the general installation position of the air conditioner. It is
necessary to investigate whether the environmental location is suitable
for transferring the air conditioner, and then prepare the required
materials and equipment. Including a set of refrigeration repair tools
and expansion screws for fixing indoor and outdoor units. There are also
pipelines that need to be updated, extended, etc.
2.回收制冷劑:把空調器中的制冷劑收集到室外機中去。拆機前應啟動空凋器，可用遙控器設定制冷狀態，待壓縮機運轉5-10分鐘，制冷狀態正常后，用扳手擰下外機的液體管與氣體管接口上的保帽，關閉高壓管(細)的截止閥門，l分鐘后管外表結露，立即關閉低壓管(粗)截止閥門，同的迅速關機，拔下電源插頭，用扳手擰緊保險帽，至此回收制冷劑工作完成。也可采用室內機上的強制啟動按鈕開機，同的觀察室內、外機是否還有其他故障。
2. Recover refrigerant: collect the refrigerant in the air conditioner
into the outdoor unit. Before dismantling the machine, start the air
conditioner and set the refrigeration state with the remote controller.
After the compressor operates for 5-10 minutes and the refrigeration
state is normal, screw off the protective cap on the interface between
the liquid pipe and the gas pipe of the external machine with a wrench,
close the stop valve of the high-pressure pipe (fine), and immediately
close the stop valve of the low-pressure pipe (coarse) after 1 minute of
condensation on the surface of the pipe. In the same way, shut down
quickly and unplug the power plug, Tighten the safety cap with a wrench,
and the refrigerant recovery is completed. The forced start button on
the indoor unit can also be used to start the machine, and observe
whether there are other faults in the indoor and outdoor units.
